Daker DK Plus convertible UPS with battery
Single phase VFI – 5000 VA – 5000 W
#3 101 73
PRODUCT DESCRIPTION
Product characteristics
Convertible UPS with batteries Single phase
• The stated backup time in minutes is estimated and may vary according to the load characteristics, operating conditions and environment
• Nominal power: : 5000 VA
• Active power: : 5000 W
• Backup time: : 6 min
• Weight: : 60 kg
General characteristics
DAKER DK PLUS – On-line double conversion UPS (rack/tower) – single phase and three phase VFI
• The main parameters of the UPS, including the battery charge level and faults, are displayed on the LCD screen on the front panel
• The integrated communication software not only controls the UPS and its switch-off if there is a malfunction, and enables the user to test the main functions remotely, communicate via SNMP/Internet/network adaptor and access the functions of the UPS via the Internet, but can also send the user an SMS if specific events occur
• The internal extension connector enables aWEB/SNMP card or a relay interface to be installed which provides insulated contacts for applications on industrial control panels or remote alarm panels
• If there is an electronic fault, overload, overheating or for scheduled maintenance operations, the automatic or manual (optional) bypass ensures continuity of the power supply for critical loads. A bypass switch is available for maintenance
Specifications UPS Legrand (3 101 73)
General Features
• Nominal power (VA) : 5000
• Active power (W) : 5000
• Technology : On-Line Double Conversion VFI-SS-111
• Waveform : Sinusoidal
• UPS architecture : convertible tower and rack 19
• Surge Rating : 1900
• ECO Mode efficiency : %98
Input
• Input voltage : 230 V
• Input frequency : 50-60 Hz ±5% Autosensing
• Input Voltage Range : 170V – 288V on full load
• THD Input current : < 3%
• Input power factor : > 0.99
Output
• Output voltage : 230V ± 1%
• Output frequency (nominal) : 50/60 Hz (can be set from the LCD panel) +/- 0.1%
• Crest Factor : 1:3
• THD Output voltage : Linear load 2% Nonlinear load 5%
• Output Voltage Tolerance : ±1%
Batteries
• Uptime Expansion : No
• Number of batteries : 20
• Battery series Type/Voltage : 12V 5Ah
• Uptime with 80% load (min) : 4
Communication and management
• Display and Signals : Four buttons and four LEDs to monitor the status of the UPS in real time
• Communication Ports : RS232 serial ports, USB
• Remote Management : available
• Network interface slot : SNMP
Mechanical features
• Measurements H x L x D (mm) : 440×176 (4U) x680
• Battery Cabinet Measurements H x L x D (mm) : 440×132 (3U) x680
• Net Weight (kg) : 60
Environmental conditions
• Operating temperature (°C) : 0 ÷ 40 °C
• Degree of protection : IP20
• Relative humidity (%) : 0-95% non-condensing
• Noise level at 1 m (dBA) : < 50
• Heat Loss (BTU/h) : 982
Certifications
• Standards : EN 62040-1, EN 62040-2, EN 62040-3